A-B Loop by Frame

[Gooseye]

I have been trying to figure this out for a while now, I have googled this to death but can't find an answer.

I want to do an A-B Loop by frame instead of time, is this possible? I can't even figure out how to display the Frame Counter.

My issue is, when I loop by time, the A-B Loop starts and ends on the second, but I want to start or end on a half or quarter second.

I have tried to figure out if it is possible to use milliseconds for loop, but I haven't figured that out either.

So basically, either being about to set the loop by frame or milliseconds would work for me. Is either of these possible?

[rvm]

I think mpv only supports loop by time, not by frame.

https://mpv.io/manual/stable/#options-ab-loop-b

[Gooseye]

Ok, thank you for the response, I was thinking that may be the case.